FI Cleaner Tool

Wipes the FI error codes from the ECU
Fast and cost effective FI error code wiper for Euro 4 emission class motorcycles - just plug it in and get the job done effortlessly!

Lightning fast
Just plug the FIC Tool into the diagnostic connector of the motorcycle, turn the ignition key ON and see the result on the bicolor status LED.

Saves cost
It is much quicker and more convenient to use the FIC Tool for clearing errors than using an OBD Tool. Faster turnaround and lower costs for workshops.

Advanced tech
Being motorcycle brand-specific, each FIC model is compatible with many bike models/years within a brand.

Introduction
The FI Cleaner Tool is compatible with a wide range of the current Euro 4 emission class motorcycles (2017 onwards, depending on make/model). The engine management system monitors the various sensors of the motorcycle. Whenever there’s a fault in the system, the FI light will come and stay on even if the fault condition no longer exists, e.g. a loose connector was reconnected. It takes several full running cycles and a lot of time to get the error cleared without an OBD Tool. This is when the FIC Tool comes in very handy for workshops – it saves a lot of time whenever working on a motorcycle.

Note: The FIC Tool will not clear the FI light if the error is still active. However, it will clear it in a few seconds if the problem has been resolved.  The FIC Tool will not clear the error history (stored errors) from the ECU, so it will still be possible to troubleshoot recurring problems later.